This website requires certain cookies to work and uses other cookies to help you have the best experience. By visiting this website, certain cookies have already been set, which you may delete and block. By closing this message or continuing to use our site, you agree to the use of cookies. Visit our updated privacy and cookie policy to learn more.
This Website Uses Cookies By closing this message or continuing to use our site, you agree to our cookie policy. Learn MoreThis website requires certain cookies to work and uses other cookies to help you have the best experience. By visiting this website, certain cookies have already been set, which you may delete and block. By closing this message or continuing to use our site, you agree to the use of cookies. Visit our updated privacy and cookie policy to learn more.
Home » Accessory for work platforms by Hydro-Mobile
The Bearing Bridge Adapter serves as a link between a bearing bridge and two P Series units allowing amplify the installation significantly. Consequently, the P Series configuration can become as extensive and wide-ranging as 84 feet instead of formerly 56 feet while using two independent units. This type of set up may allow one to use fewer units while increasing your workspace, thus optimizing your savings. Further this new accessory with a deck dimension of 30 inch by 60 inch and a total weight of 190 pounds will lengthen workspace by 30 feet with almost the same weight capacity.