Snap Lock is designed to be installed as the wall is being framed. In essence, stud spacing is accomplished by the product. The bridging bar has a starter clip that can be used in the first stud of a run. A screw at the beginning and at the end of a run are the only screws needed no matter the length of the run. Other bridging products require clips and screws at every stud. The product is available in 20- or 16-gauge steel and 16- or 24-inch lengths. If a different length is needed, maybe at the beginning or end of a run, the bridging bar flanges can be snipped. The product then can be folded over and screwed into place using the small pre-punched holes. Larger holes are also provided in Snap Lock to allow for other products, such as conduit, to easily pass through. For more information, watch the YouTube tutorial or visit flexabilityconcepts.com.