Archived Webinar on Exterior Wall Assemblies Available for Free Download
W&C
Architect’s Webinar “Four Barriers for Four Wetting Potentials: How to Design
Successful Exterior Wall Assemblies” is now archived and readily available for
download from our site. The event was presented by Len Anastasi, president of
EXO-TEC Consulting Inc., on November 29. The presentation was followed by a 15
minute Q&A with Anastasi.
Listeners to this Webinar can still receive CES credits once listening to the whole 60 minute event. There is a test following this Webinar which must be completed to receive the credits.
This free 45-minute presentation discussed the four basic wetting potentials that above grade exterior wall assemblies are subject to due to the differing climates between indoor and outdoor climates. These barriers need to be identified and located properly within the assembly in order for the assembly to effectively deal with the wetting potentials. This presentation identifies these four barriers, informs participants which barriers will deal with what potentials and show the participants where to locate the barriers based on their physical properties in order to design a successful exterior wall assembly.
In addition to W&C Architect, the Webinar is also brought to you by CertainTeed, ClarkDietrich Building Systems, Extrutech Plastics Inc., Hunter Panels, Parex USA and Total Wall.
To listen to this Webinar, please click here.
W&C Architect’s new Webinar will be on BIM, held February 22, 2012. The event will be presented by ClarkDietrich’s Robert Warr, P.E., LEED AP, Director of Engineering Services. Stay tuned for more information on this important Webinar and for registration information.
Listeners to this Webinar can still receive CES credits once listening to the whole 60 minute event. There is a test following this Webinar which must be completed to receive the credits.
This free 45-minute presentation discussed the four basic wetting potentials that above grade exterior wall assemblies are subject to due to the differing climates between indoor and outdoor climates. These barriers need to be identified and located properly within the assembly in order for the assembly to effectively deal with the wetting potentials. This presentation identifies these four barriers, informs participants which barriers will deal with what potentials and show the participants where to locate the barriers based on their physical properties in order to design a successful exterior wall assembly.
In addition to W&C Architect, the Webinar is also brought to you by CertainTeed, ClarkDietrich Building Systems, Extrutech Plastics Inc., Hunter Panels, Parex USA and Total Wall.
To listen to this Webinar, please click here.
W&C Architect’s new Webinar will be on BIM, held February 22, 2012. The event will be presented by ClarkDietrich’s Robert Warr, P.E., LEED AP, Director of Engineering Services. Stay tuned for more information on this important Webinar and for registration information.
Looking for a reprint of this article?
From high-res PDFs to custom plaques, order your copy today!
